Here is another visor. This time for the Garmin Striker Plus 7SV and 7CV Sounder/Fish Finders
Its a very simple print with no supports at all needed. Its a fairly long print though, at over 20 hours. (0.2mm @ 50mm/s)
Print with at least 4 perimeters. There is very little infill, but use at least 50% for some extra rigidity.
4x M4 x 6mm Stainless Steel screws are recommended. (5mm would be ok) (The mounting backing is 2.5mm thick and the Striker Plus holes are 4.8mm deep)
If you download and like this design, please show your support! :)
Enjoy and tight lines!