Enclosure for the stock control board for the Creality Ender 3, with optional 80mm fan lid.
Ideal for separating the electronics from a closed enclosure for the printer.
Should work with the SKR Mini E3, and probably works with the MKS Gen L with a board adaptor (not tested, adaptor not included).
IMPORTANT: Print requires supports for the front and back holes (see photos of finished print).
Unless you print in ABS, the mounting holes can be threaded with the stock screws if you heat them for 5 seconds with a soldering iron and screw them while hot (be extremely careful).
-Takes factory M3 screws
-Can use stock metal lid and fan
-Optional 80mm fan lid (fan on the outside)
-Mountings for 2 x LM2596 / XL6009 voltage regulators (43x21mm boards)
-Plenty of vents
-Slits for securing the cables with zip ties
-Fairly rigid design
Visit my 3D store: https://www.shapeways.com/shops/usuariu-s-3d-shop
If you enjoyed my model, consider leaving a small donation here
Don't forget to post your print! Cheers
-PRINT WITH SUPPORTS FOR THE FRONT AND BACK HOLES
-Takes about 10h to print at 0.2mm layer height