8 pcs. M2,5x20 screws ISO 7380, ISO 4762 or similar (fan)
8 pcs. M2,5 nut
assemble case as shown on pictures.
you might want to widen the holes for the screws with a drill (depending on the printing quality you select) or (as I prefer to do) before assembling anything to the case, use a blow torch to warm up the screw brackets and screw in the screws to gently form a thread inside the brackets. Let i cool down for a few seconds and undo the screw again.
snap rail clips into printer rails.
lift printer and let the clips glide into the brackets of the case.
In the V2 files I added an improved clip (old one was snapping) and a base with a cut-out to take out the raspberry microSD card without disassembly.
In the V3 files I changed the fan grid to vertical slots for easier printing
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.