A Coffin Bass broken down to fit on a 200mm x 200mm bed.
Designed to work with EMG pickups, a JHZ set plus a 35HZ at the neck, all wired J-Bass style with 3 volume pots & 1 tone pot.
Bridge is classic fender style but use M3 bolts & nuts in place of screws.
Intended for a fender type J-Bass neck
weld bevel has been incorporated into the part to save time & add strength
current print settings are;
20% infill ( Kisslicer straight pattern)
pla @ 220c
recommend 3 shells or more
support needed for parts B & C
assembly with friction welding using pla filament
weld C to E & B to D first then (C,E) to (B,D) & finally A to (B,D).
This should provide the strongest possible assembly.
Bridge fitted with M3x40 countersunk bolts