I wanted a toolholder for all my inbus keys, found one here on thingiverse, but it was flat.
I do have a toolbag, which only has pockets for the typical screwdriver, and i wanted something that fit where a screwdriver is, doesnt slip through the pockets, and maybe fans the inbus keys a bit out, so you can get them out easier.
So i modelled this up in fusion 360, did one prototype where all the holes where off, did a second one, and thats the final one you see in the photos.
And i must say, it does that job very well!
Goedis (GER) PETG
Printed on a TEVO TORNADO !
The printer selection is buggy again.
Printing temp was 228°C on a 70°C bed.
I simply measured the profile of my trusty screwdriver, and put that into fusion, added a few steps through "offset plane", put holes in that, and BAM! there it is.