This is a mold for making Silicone Sock insulators for the Prometheus v1.1 heater blocks.
You'll need a high-temperature silicone to work with, either a two part mixture, or an RTV single part will work. I used this kind
- Latex gloves
- Disposable bowl/dish
- Dish Soap
- 2x M3 12mm screws
- Optional but very helpful: 1½" Ratcheting C-Clamp
Check this post for instructions on how to use this mold
Check out my other socks for other hotends:
The handle and insert need supports, but all other parts can be printed as-is.
for higher temperature rated silicone, be sure to sand the layer ridges or use epoxy to smooth them down, or the silicone may bind with the plastic