Behuizing van rgb jongleerkubus. Meer op https://www.circuitsonline.net/forum/view/message/2065202#2065202 en wellicht later op https://lukelectro.wordpress.com/
Maar ook bruikbaar als behuizing voor andere lichtgevende kubus- projectjes.
Also usable for other Light Emmiting Cube projects, but meant as a housing for jugglecube.
The middle fits a 50mm diameter 1.6mm thickness circuit board.
Print instructions are in .scad. I'd suggest translucent PETG for the halves and anything flexible for the middle (I used transparant flex45 TPE, which isn't even translucent but otherwise ok.)
Please let me know if this was useful for you and/or sent me a picture of your "make" :)
whatever PETG / TPE
translucent / natural
print the halves wit a large nozzle and layer height, say 0.8mm / 0.5mm. For optical clarity.
Print the flexible part wit a 0.4mm or other small nozzle and "normal" settings, maybe a bit slower because it's flexible.
with m3 nuts&bolts and optionally eyelets for wiring connected to those bolts.