Contents
Tags
Design Tools
A part of these Groups View All
License


Liked By View All
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.
Print Thing TagSummary
Ich habe mein Projekt Motorradgriffheizungsregler nun erfolgreich abgeschlossen.
Zum Regeln habe ich einen LED Dimmer für meine Zwecke umgebaut, die Regler gibt es im Netz für kleines Geld.
Ausgelegt sind diese für 12V und bis 8 A Strom.
Am Regler habe ich das vorhandene 1K Ohm Poti gegen eines mit Schalter getauscht, der Schalter kann aber nicht diesen hohen Strom schalten.
Deshalb habe ich auf der Platine die Versorgung der Regelelektronik hinter der Diode unterbrochen und mit dem Schalter gebrückt, sodaß nur die Regelelektronik geschaltet wird.
Dazu eine Kontroll LED mit Vorwiederstand 560 Ohm verbaut.
Die Anschlüsse sind auf dem Foto zu sehen.
Heizgriffe sind von Daytona, diese haben 60 Watt und sind parallel am Regler angeschlossen.
Das Ganze dann an 12V über das Zündschloss am Anschluss für die Hupe ( ist separat Abgesichert bei der Suzuki) angeschlossen.
Funktioniert tadellos und lässt sich stufenlos regeln.
I have now successfully completed my project Motorcycle Handle Heating Controller.
I have rebuilt an LED dimmer for the purposes of the rules, the regulators are available on the net for a small fee.
These are designed for 12V and 8A current.
On the controller, I have exchanged the existing 1K ohm potentiometer for one with a switch, but the switch can not switch this high current.
Therefore, I have interrupted the supply of the control electronics behind the diode on the board and bridged with the switch, so that only the control electronics is switched.
For this purpose, a control LED with Resistor 560 ohm installed.
The connections can be seen in the photo.
Heated handles are from Daytona, these have 60 watts and are connected in parallel to the regulator.
The whole thing then to 12V via the ignition lock on the connection for the horn (is separately secured on the Suzuki) connected.
Works perfectly and can be infinitely adjusted.
Print Settings
Printer Brand:
Deltaprintr
Printer:
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0,2
Infill:
50