This rendition of the 1960's Tardis is based on an original by Vargr. I had symmetry/alignment problems with some parts, of the original version, so opted to redraw them and add channels etc. for LEDs and wiring at the same time. I've kept the hole down the middle of the column the same size as the original, so the actuator addition should also be able to be used with this version. The top and bottom parts have holes to add alignment pegs (a short piece of filament). I would recommend orienting the top and bottom parts in the same direction when printing, as even the smallest misalignment on your printer will show up when you put the parts together.
Parts of the Time Rotor internals have also been redrawn and an optional spacer has been included to keep the time rotor in the up position, should you prefer it that way. The panels are the originals, but they do have to be rescaled (7.7% of original size) and have some repairs done on them. They could do with some modifications and other minor fixes, especially with regards to the longer control levers; after rescaling, they are very thin, can be difficult to print and break easily. At some point, I may get around to thickening the control levers.
This model is scaled for 5-1/2" figures