I made this Citadel Paint holder for my pegboard as none of the others on thingiverse had the correct spacing for mine("Küpper Lochwand"), which has about 34 mm distance between the big holes in them. Make sure to measure the distance of the wholes before printing!
I also wanted to make sure this stays fixed, so everything is very tight and i had to use a hammer to tap it into place(don't worry, it is not that hard). Since I am not going to rearrange the pegboard every day, this had absolute priority for me.
Since I have a lot of Citadel colors, I also wanted to make sure to not waste material on unnecessary things, so this is a very minimalistic design.
I have also attached the *.ipt file, so you can redesign it easily(careful I first designed it to be only 4 paints wide and then moved up to 5 paints, which is why the way the small extensions that go into the pegboard are designed is not that nice ;-))
The paint holders are specifically designed to be sturdy, require no support and no work after printing.
- place it in the pegboard
- press down one of the pegs in one hole to make sure it won't fall out
- Turn a hammer 90° sideways to tap the paint holder down. It requires some force, but the force is distributed over a wide area so nothing will break.
- The Paint holder will sit perfectly in the pegboard and won't move any more.