I noticed a lack of vases here on Thingiverse, and decided to make one more... Nothing too fancy going on, just three vases inspired by graphene and its hexagonal lattice structure. Please send a make if You decide to print any of the designs, or try to print this in actual graphene!
You must enable "vase mode" or spiralized outer contour in Cura terms, or this will end up as a solid block instead of a vase.
Check out my other designs here: https://www.thingiverse.com/Superbeasti/designs
Das Filament PETG
The outer surface was sanded with a 400 grit paper to give a matte surface, and to contrast the hexagon structure.