Case for a T12 OLED Soldering Station Module including a 24V Power supply (158x98x42mm).
Start with wiring up the power supply to the AC connector, switch and T12 power connector. Now place it into the case. I didn't fix it since it is quite stationary, you should however be able to use some plastic to wedge it in place or just add some hot glue or silicon.
Fixing the back AC connector might be a bit tricky because you can not reach the lower screw. Either put the screws on the inside or glue a nut on the inside before inserting it. I suggest to use nylon screws and nuts to avoid exposed metal.
The controller, connector and switch are fixed using the original nuts.