This is a holder for my Dremel MultiPro 770. It allows you to use both hands on the piece that you are working against the dremel. The holder has three notches cut on each side. The back two are suitable for attaching it to a larger base or table with posts. The front notches are designed to anchor the table. The table prints upside down with the top against the platform. The Table risers can be anchored below the table, in various combinations, to adjust the height of the work space around the tool attached to the dremel (sanding, cutting, etc.). The holder was designed to work horizontally, but should work either horizontally or vertically, if properly secured.
I saw a couple of similar holders on here, but nothing that fit my Dremel MultiPro 770. I wanted a large, stable base, with a large interlocking section for soundly docking the table.
xyzPrinting Da Vinci 1.0 Pro
Amazon Basics PETG
The table has a bridge, but I was able to print it without supports.