Often I need a plate to mount FC, VTX or RX in middle of the stack. Therefore I placed one hole, so you can simply add it where you want - not only on top of your stack.
- FC_Halter_v4.stl hole from start to end, tight version.
- FC_Halter_v4_large_holes.stl more loose version, just slightly.
- FC_Halter_v4_flat.stl without spacer elements attached, just as a plate.
Good to know
I'd like temperature changing filament very much - so you can see heated elements by plate they are placed on: White means warm and purple means cold. Great stuff!
Kudos I like original design, looks stylish :)
My additional settings
- Temperature: 215 degree
- Bed temperature: 60 degree
0.2 mm if you like it nice
0.3 mm works as well and is faster in printing
... but it's a small piece and usually finished within minutes ;)