Remixed 40mm fan guard to add Papsi's LED bar to print all in one piece.
Print face up with supports enabled - only the LED bar wings should be touching the bed.. Custom supports are built into the model for the wings, but you'll need your slicer to generate supports to hold up the rest of the fan guard during printing.
For the LEDs I bought the 6" sample size of the 24V 2835 LED strip found here: https://www.ebay.com/itm/TECLED-Eco-UL-16ft-LED-Strip-Light-Warm-White-3000K-576x2835-24vDC-CRI80-72W/122602326095. I found that one 2 inch unit (there's scissor marks to show where to cut) fits perfectly.
4/30/19 update - uploaded V2; replaced fan guard portion of the model with a slightly lighter weight variation (hollow center cone & a couple mm thinner overall).
Amazon Basics PLA+