So being the overcautious miniquad builder that I am, I was concerned about the battery sliding forward and the cells or leads being cut by the stack cover plate on the Ichabod Jr. So I designed this 'Battery Bump Pad' as a nice spongy surface for the battery to sit up against. It is intended to be used with the stock 20mm standoffs that Andy currently sends the kits out with.
I've designed this part to use minimal support and you can definitely get away with using no support at all. If you are going to use support however, ensure that it is only set to be used for overhangs of no less than 50 degrees.
Print in TPU - I recommend Sainsmart TPU (which is what the majority of miniquad parts are printed with).