A jerk lure which I made while training 3D modelling.
70 mm long, 25 mm high and 15 mm thick at thickest.
You need to add weight to make it sink. There is 5 mm room for weights at back section and 8 mm at front. Recommended to balance the jerk nose heavy. Add lead pellets to gain rattling effect.
Add weights, frame wire and glue halves together. Paint if you wish. Note: Painting and clear coating will hide the pattern. Use maximum of one layer of clear coat.
Work in progress.
03.05.2019 - V1.00 Initial release
04.05.2019 - V1.01 Changed wire frame hole orientations
The side pattern is made with 0.2 steps in height. Maximum resolution 0.2 mm but 0.1 mm is recommended.
You need to mirror the half in slicer to have both halves.