I installed a BLTouch to my CR-10S Pro and decided I did not like the idea of its cable flopping loose next to the ribbon cable so I designed a clip to secure it to the ribbon cable and clean up the routing and look. The blue one in the picture was my first go, then I redesigned it so it has a locking clip on the open end as well as a standoff for a zip tie where the BLTouch cable routes through.
I since stumbled upon where someone else had designed a clip for this also. that clip would not have worked for me as I sleeved my cables and needed a routing option for the round sleeving anyhow.
As printers are all different you may need to scale up/down a small percent for best fit.