This is a portable pen holder for a Moleskine or comparable journal. I wanted to make a place for a pen or pencil without damaging the integrity of the notebook. it slides over the back or front of the cover. The model was made in Fusion 360 and I added support via Meshmixer. I have found Meshmixer's support much easier to customize and remove from builds. The support was easily removed with needle nose pliers.
The build shown was 0.2 mm on Prusa MK2 with Hatchbox grey at 195 C. Build time was about an hour.
Depending on the "field test", I may have to make modifications. Let me know what you think!
200 C first layer and 195 C build. Bed at 60 C.
I am still learning Fusion 360. This was relatively easy to make and can be modded.