First open the adapter and assemble the 2 small parts with 2 screws
Add protection foam, rubber (<1mm thick) or thick tape around disk before mounting the last part.
Be careful the the side. The disk may have a "Do not cover" hole. And do not cover it
You may have to sand a little the 2 small parts (where there is the screw hole) if you have printed with support
Assemble the third part and close the case with 2 screws
Sample print settings
Small parts :
Infill : 30%
Support density 10%
Speed : 60mm/s
Layer thickness : 0.2mm
Time needed : 2 * 1h30
Big part :
Infill : 20%
No supports (vertically printed, screw hole at the base)
Speed : 80mm/s
Layer thickness : Adaptative
Time needed : < 4h
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.