Designed for printing in spiral / vase mode.
Plastic weight: only 6g for
2p model and 7g for
Printing time: ~1h (on my printer and settings)
Designed for batteries up to 66.2mm, on these sizes the latch holds tight.
May not work with some large batteries with protection, depending on the specific instance.
Spiralize Outer Contour: enabled
Line Width: 0.6 mm
I also recommend reducing the
Print Speed to 10mm/s, especially if the nozzle is less than 0.4mm. This will increase the print time by a few minutes, but can significantly improve the quality and strength of the bottom.