This thing is a little Puzzle Ball Maze 60x60x30mm
The objective is to get the ball from one entrance and
out of the other .
It is my first attempt to make a Puzzle with a ball and
it is only half of the size of what i have in mind to make
and later on it will allso be a twisty maze with 3 rotating sections.
I had to momentary stop making it the full size in order to
try it out myself .
I can make it seriously difficult with traps but that i have
avoided with this one , feel free to download it and
try it out for yourself .
Leave a comment if you think it is to easy etc.
Note: This design can only be used with a ball from 6mm and up to 6.5mm
i would suggest to use a steel ball ,mine came from
a bearing that i disassembled .
Note 2 : Watch out for filament sag ,i had several stringing of filament
sag ,so had to push a small screwdriver into the holes to remove
Note 3 : In the case you have problems in solving this maze ,i have
uploaded fusion360 pictures of the pathway through the maze
but they are not clear enough to show the hole pathway ,
so please use it as a form of guideline
Filament that came with the CR-X pla
You need to have your settings tweaked good ,because otherwise
you will get to many filament sag in the holes and though ruin
the maze .
I still had some filament sag but nothing more than i could get
rid of with a small screwdriver