This is a little but very tough and sturdy desk stand
for small tools ,use it for scissors , pliers ,tweezers ,
screwdrivers and even your unbraco keys ,just use
the adapter and your good to go .
Total height is 152mm and the diameter is in top 124mm
and the foot is 150mm in diameter.
The 21 big holes is 20mm in diameter .
If you found this design very helpful or otherwise wish to support me ,you can buy me a cup of coffee ( helps keeping the brain active so i can create new stuff ) ;-) ,then please
consider using this link :
To assemble this you need the following :
4 pcs of m4 x 10-12mm hex socket bolts
4 pcs of m4 x 14-16mm hex socket bolts
8 pcs of m4 nuts
Be aware of that there is a top and bottom of the
tube piece ,you can see the difference in how far
the m4 nuts are sitting up/down on the tube .
If you assemble it wrong you can see the m4 nuts
hole at the foot of the tools stand .
3de Premium Pla Max
I do state in supports that it is not needed but
you might wan't to have supports turned on
for the holes for the m4 hex socket ,but
it should all-so work without if your printer
is dialed in fine regarding overhangs .
The 20 procent infill is fine for the tube and the
top piece ,but i do recommend a higher value
for the foot piece ,mayby around 40-50 % infill.