Donations are welcome!
If you like this "thing" please think about donating. Even if it is only 1 $€£.
It takes a lot of time to design these things and a small donation will motivate me to design more.
Thank You !!!
This design is inspired by https://www.thingiverse.com/thing:3177276 but much smaller.
I printed eveything at 0.1mm but the inserts can also be printed at 0.2mm-
The 8mm insert is a bit tricky to print - use a large Brim to make sure it will print OK.
You could also print Part A&B and the 6mm insert at 133% size to get a 8mm stop.
Printing the 8mm stop at 125% should give you a 10mm stop.