DON'T USE "DOWNLOAD ALL FILES" - THERE IS A BUG IN THINGIVERSE - DOWNLOAD IT BY "THING FILES" !!!
There was a bug in the design of Air Duct - it was too short and the air was cooling Heater Block.
If you downloaded the design before 2019.06.12, redownload it again and print Air duct ver. 4.0.
This is a third version of minimalistic Fan Duct.
Minimalistic Fan Mount in the beginning was mod for "MINIMALISTIC ENDER 3 FAN MOUNT", now is new design and new project.
Version 3.0 is completely redesign and you can't use elements from version 1.0.
The Fan Mount v 3.0 is very light construction, with ease mount and good cooling effectiveness. Many features was redesign and tested in comparison to earlier versions.
Bltouch mount offsets:
Distance from head: 27 mm
y = - 1.7 mm
Screws from bottom too up:
AIR DUCT LOWER MOUNT
2x M3X10 or M3X8 - careful it can break or go thru the base !
AIR DUCT UPPER MOUNT
2x M3X15 or M3X20
MAIN FAN MOUNT
FAN AIR DUCT MOUNT
MAIN BODY MOUNT TO PLATE
- Better alignment,
- All metal Hot-End (Swiss Hot-End) better compatibility/alignment,
- Thicken walls - no more warping,
- Cable management,
- A hook for vibration / noise reduction,
- Bltouch mount,
- Air Duct - easy mount from front with mask,
- Air Duct air flow redesign with two additional mounting point for more noise and vibration reduction,
- Bowden tube leading for friction reduction compared to previous version about 40 %,
- Main Fan vortex reduction the air has a linear flow,
- Some small improvements.
Polymaker Polymax, Noctuo UltraPLA PLA
Body Black, Air Duct red, Fan Mask Black or Red