UNTESTED - this model, once properly balanced should fly quite well on an 18mm D.could even work on a C6-3.but I've not had the chance to test fly it yet.
Estes BT-50 body tube (236mm length)
Estes BT-20 body tube (78mm length)
2 Screw eyes
Paperclip or thin piano wire for motor retention
Because of the fin spread a special launch stand is offered. I suspect it won't suffer too much damage from a launch but keep an eye on this. I printed mine with Polycarbinate filament. It may need a heat deflector.
I would use shotgun shot to add weight to the nose cone to bring the cg more forward of the fins
there are small holes in the nozzle to allow for the paperclip or piano wire to retain the motor. The heat from the motor shouldn't cause the plastic holding the clip to fail, however this design is untested so be aware of that potential.
When gluing the PLA parts to the body tubes, I've had no issue using white glue.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.