NEW WORKING VERSION
Clearly to small to fit anything, don't print!!!!!!
Portable fpv wing. Designed to give the best fpv experience and to keep you as long in the sky as possible!
The battery is supposed to be put on the bottem of the wing with a batterystrap just like a racing drone. A gps must be fitted on the battery strap, because there is no room left in the wing and there is no real standard size gps.
All the other components can be mounted inside, a drone ESC, VTX (mmcx port, there is no mount for sma), Flight Controller, Receiver and camera.
The motor mount uses 16 x 19 mounting holes.
Two 8 mm spars hold the wings together and give strength.
The plane is not yet printed and has not flown yet!
glue the fuse together
the fuse is printed in two pieces for easy printing. This means that you have to glue them together.
Insert the spars while gluing to make sure it is properly aligned, and apply glue on all the edges that are touching. For maximum surface area the bottom is wavy.
Sand the parts before gluing if necessary.
Make the wings!
Use a hot wire cutter to cut the wing cores. There are a lot of tutorials online.
I Used EPS and XPS foam, although EPO and EPP are the strongest.