Loading
Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!
icenyne

Anycubic Chiron 5015 Blower Shroud for Stock Hotend

by icenyne Jun 1, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

Hey, thanks for your design.

I posted a make. Only used the part cooler.

A few ideas for improvements:
1) The screwholes that mount the partcooler to the Base could have a bit more space for lager screwheads
2) You can basically remove the hole for the radial fan intake and only have a L_Shape. Would fit more hole diameters, more space for air intake and fewer turbolences. Have a look at this: https://www.thingiverse.com/thing:3544699
3)I havent tried to view the air with smoke/Vapor but it feels like most of the air is coming out from the left side. Maybe with an internal structure/chanel or different outlet sizes you could improve the flow.

What did you use to design this? Maybe you can share your files :)
But thank you again, for me this is close to perfect.

Btw. Havent tried the levelsensor yet

Simple 5015 Blower Anycubic Chiron for mk8 E3d V5 V6
by galagor

I've added the link to the TinkerCAD project. The pieces are ungroupable/editable, so they can be edited from where I left off. (The thing you referred to is actually the single sided version of what I started with...)

In attaching the Rev3B shroud to the blower holder, I ended up cutting out an internal baffle. Since I only had the STL of Rev3B and am relatively new to 3D modeling, I couldn't do much more than creatively add and cut as I did. If you do do any smoke tests, please share the results.

I don't care for the hotend cooler and connector holder - I think I may switch to the cooler connected to the hotend fins. The connector holder can be attached to the left side piece...