Adjustable helmet stand
4" & 6" dia. Base adds about 1" in height
Top adds 1.5"
Some tolerances are tight. You may need to sand the pegs a bit.
7% or more infill for top and bottom
15% infill for risers
Print without bottom layers and fill with plaster for a more stable stand.
Added new style tops that sit flat, 45' and 60' angles. Use angle adapter with new tops.
Added larger 6 inch base
Added Screw shaft and riser
**** Wall mount is a WIP and not complete.
sand pegs and risers as needed. Lube if necessary.
Add grip tape to reduce chance of mask slipping off angled tops