A quick (And dirty) Remix of tsm14086's excellent 775 DC motor mount (https://www.thingiverse.com/thing:3320083)
There is plenty of mounts available for the useful little 775 DC motor but I was un-able to find any for its bigger and torque-ier cousin the 895 DC motor, They are very similar in size but the 895 is a bit bigger although utilizing the same bolt holes it will not fit in the 775 mount.
I merely sliced the 775 bracket in half and added a few extra mm of material to allow the bigger motor to fit, also not the 775 will also fit in this bracket if you shrink it down to %96 so if you are using a 775 motor and need it to sit slightly higher than in the original version this might be a good fix for that.
(Please keep in mind I'm a complete novice when it comes to 3D modeling and am completely aware this could have been done much nicer without much effort, I am but a mere mortal and have yet to learn how) . But if you need a quick bracket for your 895 motor and don't have time to design one this will do the job.
printed out fine on my test runs with %20 infill and no rafts, results may very.
Keep in mind as most of these DC motors come from china the tolerances are not perfect, I've had 3 motors fit this mount fine but another 895 motor needed the mount printed at %101 of the size, no clue why thats just my experience