These are the OEM stock parts for the BQE RIP Squeak.
The cam mounts are intended for a micro size fpv camera.
The Tail mount has mounts for 2 RX antennas at 90º, suitable for a diversity antenna or the TBS 90º antenna. There is a third support for a Foxeer Lolipop or similar ufl antenna, which runs up the center of the support and is zip tied tight.
They should be printed in TPU with a .2 layer height or less for maximum durability. The tail piece may not print well for you if your printer isn't dialed in. Go slow, keep it as cool as possible.
RECENTLY ADDED: ARM GUARDS - there are 2 file versions, one with a built in support for the overhang, the other is just the guard with no support added. On my set up, I found that the model with the support printed a little cleaner, your experience may vary. Removing the support should be easy with needle nose pliers.