Injora Jeep JK Frame Rail DXF files.

by Intashu Jun 18, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

question for you if i send this frame to get cut is it the right size or do i need to scale it up ???

All files were made 1:1. Measurements in MM. I cannot guarantee results if sent out to an outside source to make them as I only have experience on my own equiptment and setup.

ok thank you. I don't have the equipment to cut it but know a few people that do. Roughly what is the frame length???

When bolted together its right around 413mm.

The front and rear rails are both a little over 206mm long. And designed to be bolted together with the middle plate end holding them end to end. You can extend the length 11.25mm via the middle bolts by pushing the front rails out one mounting hole set. But it was designed 1:1 with this specific jeep body in mind so I didn't intend it to really adjust much.

gonna try and laser cut this all about on monday or tuesday hgopefully!

Thx for that remix. If I will ever have the possibility to cut the parts I will try it.

haha had just posted on your jk jeep thread about maybe getting full rails so i can laser cut, then saw this guys remix haha