case&stand for SIPEED Maix DOCK
SIPEED Maix DOC
-This Thing is a simple Flip-case and stand for Maix DOCK.
-In order to assemble the stand, 4 pairs of M2.6(10 or 12mm) bolts and nuts are required.
-Perhaps, due to the revision and improvement of Maix Dock, this thing may not be suitable for it.
CAD file : MD057_.stp (.123dx)
Cylindrical parts like rolling rods are designed to rotate.
Immediately after printing, it will stick, so carefully rotate it etc. to release it.
Familiarity may be required for the attachment and detachment of fasteners of this shape.
When removing it, I think it would be better to release the small bumps on the cliff with a small flathead screwdriver etc.
A cylindrical mobile battery with a diameter of about 22 mm can be used instead of case045-stpv.stl.
Some part shapes will probably require several smaller support materials.
Carefully remove them after printing to see if it is shaped as designed.
Flexible cables are very easy to break.
Pay attention to the flexible cable when assembling/disassembling.
Top Solid Layer=3
Bottom Solid Layer=3
Skirt Offset from part=0
Support Infill %=30
Extra Inflation Distance=0
Support Base Layers=0
Support pillar Resolution=1.00mm
Max Overhang Angle=30deg
Support Infill Angles=60deg.