I needed a good controller for my Joy-Cons so I designed these. Only needs a little bit of clue. The version 1 has rounded front panel now.
Springs print best with out support other vise use support and keep the "controller" parts on there side and they will be easy to clean.
I wanted easy to use and well working controller for my Joy-Cons so here they are. There are to models of the "controller" part. I like the non cutout ones but the other ones are good too.
One of the images is the blowup photo of the controller. Use this to assemble them. Just drop some clue down in to the connecting holes and you are done. The small stick is the controller release and it goes in to the small hole fat end up.