I didn't see to many nerf flywheel models that were for normal nerf blasters. So i decided to make my own. These flywheels are similar the the stock flywheels that are in most nerf blasters but they have ridges on the side for slightly more grip. These are meant to be printed with a 0.4 mm nozzle diameter. If you have a nozzle of a different diameter then look at the printing notes below.
Make sure your printer is mostly dimensionally accurate. Since this will determine the fit on the motor shaft. This model is designed to be printed with a 0.4mm nozzle. To print with other nozzle sizes you should resize the hole to be roughly around 2mm + nozzle diameter for a better fit.
You should take all of the support material out of the bottom of the flywheel and make sure the hole in the top is clear of any obstructions. Then simply put it on your nerf blaster like a normal flywheel.