Allows use of the printed spring based Universal Auto-Rewind hubs created by Vincent Groenhuis on the multi-mechanism stand.
Other mechanism options include:
PTFE Mounting Accessories contains several arms providing a wide range of locations in which to install the tubing.
The parts below were sourced as follows:
- grey stand from my rewinder
- black parts from Vincent's rewinder
- blue parts from this page
Assemble the hub, spring, dial, and clutch as instructed in Vincent's page.
Slide a clip onto the shaft and then insert the shaft into the the assembled hub from the spring/clutch side. The flat on the shaft must align with the flat on the spring.
Press the shaft through the hub and out the bearing on the opposite side.
Install the second clip on the shaft.
Insert the collar into either side the stand.
Mount the assembly on the stand. The end of the shaft that went through the hub will seat into the collar. The flat side of the shaft will be facing upwards.
Adjust the clips to ensure the hub remains in the center of the shaft.