Loading
lightofhonor

6.6L & 7.8L MINI-ITX SFF PC CASE

by lightofhonor Jun 27, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

Could you make a version that fits a USB front panel assembly?

Can you also make a 3-slot version? A lot of short video cards now take up 3 slots.

Comments deleted.

Yes, both versions print on the Ender-3. The interior is the same, just the outer cover is different.

According to Cura, it will not fit the ender-3, it even refuse to slice it.

Correction : it will not print with a raft. Strange...

The raft makes the print surface larger. You can reduce the width of the raft of you need to use one.

No, not working... the print is taking all the z axis printable lenght.

Ok. I'd check your settings. Printed this on an Ender 3 myself.

Said it on Reddit and I'll say it on here. This thing looks beautiful. I think once I go sff, this will be the case. I have an ITX sized MSI Aero GTX 1060 6GB wondering if it will fit. How are the temps inside this thing while gaming? With the top fan that is. Thank you for sharing this!

Should just fit. Luckily the power connector on that card is on the top, not the back. There is about 177mm of space for the card and yours is 175mm (mine is 152mm).

Since everything has it's own air intake, the temps are all very reasonable even without the fan. Over on reddit I posted temps under stress with no fan. The only issue I had with no fan was on my gpu, it turns it's fan off at idle so it would heat up with no moving air. Adding the fan on top fixed that.

If you really wanted to tinker, you could modify my design and get it to hold two 120mm fans. I didn't do that since I wanted to use the same interior for both.