TIG/WIG Grinding Tool for Dremel Multitools
03.07.2019 60 deg and Combi Head for all 3 angles added
What you need: Dremel Multitool, 35mm Diamond Grinding Disk (f.eg. ebay)
Each Head has 3 positions that can be used, each Position uses a different radius on the grinding disk
Diameter available: 1.6mm and 2.4mm
Angles available: 30 deg, 45 deg and 60 deg als well as a combi head
Health and Safty Warning
You do it on your own risk
How to set up
Insert the shaft of the grinding wheel into the collet chuck and tighten it slightly (so that it still move a bit and sticks out of the lower part). Screw the lower part of the tool onto the dremel.
Put the grinding wheel onto the shaft (without the screw) and use the top part of the tool to press the grinding wheel and the shaft into the correct position. (When it fits to the lower part)
Remove the lower part of the tool from dremel and tighten up the collet chuck.
Screw the lower part on dremel again, fit the grinding wheel with the shaft and screw the needed top part on.
Use a 2.5mm, 1.7mm Drill to open up the holes if needed (or use a hot TIG elektrode)
Ready to grind
Other diameters and angles possible if needed.
Only Support for Collet needed, Don't use support on threads