After the simple idea of the circle cutting device for the GKF 12V (https://www.thingiverse.com/thing:3255907)
I came up with the idea to improve the whole thing and above all to make it more usable, after much thought came the idea of a rip fence
Also, not so bad, and then from the small edge trimmer to make a more or less full-fledged router ...
Said done, based on the base plate: there's an adapter that can used as a circlejig as well as a rip fence.
The setting for the rip fence is done via the wheel (small knob from the kerfmaker of Zeropage: https://www.thingiverse.com/thing:2979838) in the rip fence.
For the circle cutting device you have to do the rip fence and turn it over and on again, then you can insert a 5 mm shelf pin into the hole and use it as a fulcrum
Important is the pressure of the adapter and the Parallel stop base of the support as well as the subsequent post-processing,
80 mm threaded rod M6
4 x M6 x 25mm screw with hexagonal headfor the M6 knob
6 nuts M6
10 mm aluminum pipe as long as you want
The threaded rod and the screws are glued with Epoxy.
The holes in the fence and the adapter are drilled up to 6,5 mm, just for clean and smooth working.
The holes for the guiderail are drilled up to 10,5 mm make it smooth work.
Tianse PLA 1,75
yellow and Black