(Italian logo is a little bit different from the original.)
logo now has more polygons
added keychain version
dual extruder supported (not really tested but it should works)
!!! WARNING !!!
read instructions before printing
_Dual files are for dual extruder only, they don't have the square/rectangle used to align the models (dual extruder can use both models)
Single extruder Instructions:
Print the _Base model, if possible, let the slicer set automatically the position of the model in center of plate, to be aligned with next model.
When _Base is printed don't remove it from plate, change the filament, remove _Base file from slicer and load _Logo model and let the positioning as first file.
Square/rectangle must be positioned in the nearest extruder start position angle, to avoid the collision between extruder and already printed model!!!
The printer will print the square/rectangle until the correct layer, then it will print the logo on top of _Base model.
!!!!!!!!!! WARNING !!!!!!!!!!
When you start to print second model, be ready for a PRINTER EMERGENCY STOP!
High risk of COLLISION between EXTRUDER and already printed MODEL in case of error, this could damage the printer, be careful!!!
!!!!!!!!!! ATTENZIONE !!!!!!!!!!
Quando inizi a stampare il secondo modello, sii pronto ad un ARRESTO DI EMERGENZA della STAMPANTE!
Altro rischio di COLLISIONE tra ESTRUSORE ed il MODELLO già stampato,in caso di errore, questo potrebbe danneggiare la stampante, stai attento!
easy to print
projected and tested for SINGLE extruder, the logo Z position starts on top of the circle, you have only to change the filament between the 2 prints