From the film War Of The Worlds 1935. Just for a bit of fun I made this model.
I should have spent some time painting it and rubbing it down.
It will fit on the build plate of 235 X 235 (Ender 3 size). The main body and then the front "eyes" part.
I printed it in 3 bits as you can see. I really should have been more patient and did the body in one piece.
I have some vacuum cleaner hose for the "neck".
It looks like it will scale down as well (I am just trying that).
It printed well at 30%. Not sure I would go smaller though.
The screw for the holder has a slot to allow wire to go through, if you wanted a light inside.
any I used PLA
I printed the main section in 2 halves and didn't use supports. I didn't use supports for the eye section either.
To print is as 1 piece I would use supports. I am printing it with the eyes up so hoping just supports on the base will do.