Removal of heater cartridge and thermistor from Slice Engineering Mosquito can be difficult. This jig simplifies process by holding Mosquito safely and pressing out embedded cartridges with m3 x 20 mm bolts.
Use good quality bolts and lubricate the bolts prior to use.
Remove the two end screws from Mosquito.
Protect heater cartridge end with small plastic disc that is part of this thing.
Align Mosquito in jig so bolts engage cartridges. Advance screws to easily and controllably press out cartridges.
Print with at least 4 perimeters and 25 gyroid.
Press in two M3 nuts into pockets.
NB. Some stainless steel screws are very soft metal. You may be better off using alloy steel hardware.