A module based paint stand.
I made one of my sections 10mm lower since I have one set of smaler "sample" size pots.
Can be used individually or in a tower as I have done in the picture.
I cutted a pipe that was 15 in outer diameter and 13 in inner diameter.
I measured the height of the parts that I used get to the lenght of the pipe.
It is made with a 5mm spacer so you could make the pipe almost 5mm shorter.
(the spacer is to strengthen the foot)
I use a tube to fix the hexes in place by pushinging it through one of the outer hexes.
I have uploaded center rings that you could print instead ( will upload picture later on)
I used one M8 socket screw about 30-40mm long to both the top and foot to fix it in place by expanding the split rod. I used a Standard socket screw to the top and a countersunk to the foot
2019-07-28 I have changed design sligtly on both top and foot to make it easier to assemble
Center ring 01 ( made to fit into the center hex)
Center ring 02 ( made to fit into the outer hexes)
If you like my stuff please send a Paypal tip so that I can buy more sets. :D
Will focus on Warhammer Underworlds, Necromunda and Warcry.