This is an attempt to make a V6 adapter for the Mini Delta that also provides a provision for proper cooling. This requires modification of the stock effector by removing 3 -5mm of material from the back side to make room for the larger E3D heater block and also requires 3, 3mm holes to be drilled in between each set of arms at each corner of the effector. The mount will utilize these holes to attach to the effector while the duct will use two of the existing holes.
This mod will not affect your printer's z height. I've designed this to where the nozzle is in the same position as the stock setup.
5: M3-0.5 x 8mm screws
1: M3-0.5 x 16mm screw
1: M3-0.5 nut
1: 5015 blower fan
4: zip ties
Future updates will likely include installation instructions and a version that utilizes two 4010 blowers instead of the single 5015.
The adapter mount and cooling duct can both be printed without support unlike the duct adapter.