Yes, when I saw this thing, I was soooooo thankfully to the creator (https://www.thingiverse.com/WayGroovy), as I don't have to much patience with this kind of printings, they take a lot of time for a simple square thing, and the vase mode drawers were my salvation :-) Thank you WayGroovy
The original upper drawer has a problem, you can't open all the way out as it touches the Y-belt tensioner screws, so I did it in 2 pieces to fix this. The small piece is just to complete the space in the left of the drawer.
Even like this, I wanted to make it FAAAASSSTER........sorry, did I said I don't have patience? XD
So, I tried next:
Please, note THE EXPERIMENTAL OPTIONS below are very important, as because printing in 0.28, the shape in the front to open the drawer, are gonna hang ugly. With the EXPERIMENTAL OPTIONS below, that's fixed.
Gcodes _READY TO PRINT_are ready to print with an ender 3, and everything fits perfectly
But if you prefer the STLs:
Printing instructions, for people with not so much time or patience ;-)
All these options are very important, don't forget any.
Noozle: With noozle 0.4
- Layer Height 0.28
- Line Width 0.8 (yes, double than noozle ;-)
- Initial Layer Line Width 105%
A resistant one, like PETg, Nylon, ABS ...your choice
- Print Speed: My ender 3 was printing it at 50/80 mm/s without problem, but your choice
Enable Print Cooling: YES
Surface Mode: NORMAL
Spiralized Contours: YES (this is like the vase mode)
Smooth Spiralized Contours: YES
Experimental (THIS IS SO IMPORTANT TO DO)
Make Overhang Printable: YES
Maximum Model Angle: 25º
NOTE: The drawer 2 file “Drawer2complet but touches the screws and can't open.stl” or upper drawer touches in the belt tensioner screws when opening and cannot slide totally out.
Instead, you can print “Drawer2-with 5mmscrews free.stl” and the little piece “Block 5mmTo put beside the upper drawer.stl” to put beside on the left, and complete the housing, makin the drawer perfectly going out just beside the belt tensioner screws.
This 2 files, make the upper drawer in 2 pieces to make it easily slide out.