Here's a replacement toe slider for the Alpinestar SMX6 motorcycle boots
it has a different shape than the original slider because i could make the original shape 3D printable, but it fits perfectly in the little notch of the shoe.
This is a prototype at the moment, it is working, and fitting well but i might have to reffine the design later, i want to test this version on the road before i go any further :)
to print this, make sure you use 100 infill and a 0.2mm layer height or less (because of overhangs) at 205°c for PLA, also, make sure to print it slower than usual, the overhangs are printable but they look way better with these few tweaks !
later i will add a already sliced version of this, so only the sliding part and the notch that connects to the boot are 100% infill, the rest will be 25%
If you use this slider, please give me some feedback so i can continue to improve the design :)