I designed this for my 1S brushless whoop, but this is customizable and can be used with whoops of any size.
It is meant to store the whoop and six batteries.
I used the following parts for my build:
The case requires two magnets with a size of 8x3x2mm. But you can adjust the magnet size in the customizer too - you could even use a round magnet by changing the magnetShape parameter
For the hinge I used a piece of 1.75mm filament to connect the two halves of the case.
If you want to customize it for your own model the following settings will be of interest:
- hoopDiameter: The diameter of the hoops
- hoopSpacing: The spacing between the center of the motors, side to side - not diagonal.
- whoopHeight: The height from the table to the top part of the hoops
- whoopHeightTop: The height from the bottom part of the case to the top of the canopy. It is easiest to measure that once the bottom has been printed.
The STL's attached are exports of the default settings. When using the customizer, three files will be generated: one with the top part, one with the bottom part and one with both parts.
If you want to support me, feel free to leave a tip here on thingiverse, or use on of the following affiliate links (no extra cost for you, but I get comission on everything you buy) to do your shopping.