This Galleon is a work in progress. I plan to include additional floors and accessories, as well as improve the model as I test it.
Note that you need to remove the small bridge supports in the connection sockets. The sockets are imported from the open-lock dungeon tile system. These sockets have always seemed a little too snug to me, so printing the connector pieces at 90% high or so seem to help or I have to put a ton of force on the pieces to connect them, as well as shaving the inside with an xacto knife.
The capstain and masts will need to be glued down for now, though I will probably implement a way to snap them in.
Supports - The only piece so far that requires support for me is the back piece of the captain's quarters since it has a large door overhang.
To do list: helm, mid-deck, upper masts, sails, crows nest, airship conversion pieces.