Prusa Power Supply Mounting Bracket
by LittleDangerous, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
I designed this power supply mounting bracket to fit my PSU which had a different mounting hole arrangement than the ancestor part this is based off of. The ancestor part was designed for PSUs with 2 mounting holes on both sides. However my PSU has 3 holes on one side and none on the other, but it did have 4 holes on the bottom, so I designed a combination of brackets to fit each unique mounting situation.
Source files inside zip.
Note: Because the rear brackets have to go under the PSU, you will need to raise the feet of your printer up for the brackets to clear. Clear rubber feet provide just enough clearance, and keep the feet from scratching up your desk.
Before printing these off, please check the rendered 2-view image of the PSU to see if the hole pattern matches your PSU. If it doesn't, then these brackets won't work for you.
However if it does, you're in luck. Print off 1 each of the Front Left and Front Right brackets and 2 of the Rear brackets for the size of rods you are using. There is a set for 5/16" rod and one for 8mm rod. These are designed for a snap fit, so they're specific to the rod size you're using. The rear bracket mounting hole is slotted to allow for some adjustment.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
Prusa Power Supply Mounting Bracket by LittleDangerous is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving LittleDangerous a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure LittleDangerous would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).