Sculpt inspired by Jen from the Dark Crystal movie, based upon our interpretation of the characters but designed for easier printing.
This file was made watertight (manifold) and is ready for printing. We've included a screenshot of how we did our supports for this model. We followed the excellent advice of Greg Kourakos (3DPrintingPro on YouTube) to place supports in a way that the base and all normally visible areas of the model would be completely unmarked.
We hollowed this mesh in Meshmixer and prepared supports and vent holes in Chitubox. Printed on an Anycubic Photon with Elegoo gray resin at 50μm layer height, 12 second exposure time. At its default scaling, the model will stand 115mm tall (about 4-1/2") from bottom of base to the top of Jen's head. We strongly recommend hollowing the model if you are printing on a resin printer to use less resin.